Ghost 2003 works for SATA drives. I have used a bootable floppy or CD ROM
to ghost SATA drives in the past and it worked fine. I still have the boot
disks if you can get a license.
-----Original Message-----
From: Steve Bogdanski [mailto:[log in to unmask]]
Sent: Thursday, September 06, 2007 1:34 PM
To: [log in to unmask]
Subject: Re: [MSUNAG] Imaging tools for fully SATA workstations and laptops?
Most systems that have SATA drives usually have an option in the BIOS that
allows for a "legacy" mode of access. I know Dell has this and it should
allow imaging and setup applications to see the drive. However, you'd want
to switch this back after you are done, just in case it affects performance.
--
Stephen Bogdanski
Network Support
College of Veterinary Medicine
Michigan State University
>>> On 9/6/2007 at 12:16 PM, <[log in to unmask]> wrote:
> The newest systems from Dell (GX 745 & XPS1330) are using only SATA
> drives. Backup and restore solutions such as Acronis and Windows Backup
> can't restore as they don't find a hard drive. Even older Windows XP
> install discs won't load as they can't see the hard drive. Before I
> start searching for a new solutions or version - has anyone else run
> into this, and what are you using now?
>
> Sysprep & Ripprep are fine for fresh loads, but I like to make an image
> backup of laptops before doing much of anything to them when they need
> work.
>
> Thanks
>
> Don Bosman
> Information Technologist
> Libraries, Michigan State University
> 100 Library
> East Lansing, MI 48824-1048
> [log in to unmask]
> (517) 432-6123 ext 233
> Fax (517) 432-8374
__________ NOD32 2510 (20070906) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com
|