I've begun experimenting with BitLocker. I'm trying to enable it on a
Tecra M5, which is several years old. I suspect the TPM on this unit
may be a version that is too old to support BitLocker, but how can I
tell for sure what version this unit has?
When I enabled BitLocker, the system restarted, asked me to initialize
the TPM, and all appeared to be well. However now, whenever I restart
and try doing the check before actually encrypting the drive, I get an
error indicating that my boot configuration has changed and the check
fails. Has anyone else experienced this, and does it indicate the
presence of a TPM 1.0 or 1.1 as opposed to a 1.2? I would think if the
TPm were too old, BitLocker would be smart enough to just say so and not
proceed any further?
Thanks,
Al Puzzuoli
Information Technologist
Resource Center for Persons with Disabilities 517-884-1915 120 Bessey
Hall East Lansing, MI 48824-1033 http://www.rcpd.msu.edu
__________ Information from ESET NOD32 Antivirus, version of virus
signature database 3661 (20081203) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
|
